Cordon HP Speakon HQ Neutrik NL2FXX-W-S Cable Speaker Monacor SPC-525 / Sw

Speakon NL2 cord (1+/1-) of very high quality for the connection of professional sound enclosures

Equipped with the latest generation Neutrik Speakon connectors, XX series, waterproof, robust and hyper-by. Improved cable clamps and unlocking

The cable used is the SPC-525/SW monacor, ideal for conveying power audio in high-define to speakers, thanks to its multi-brinch pure copper drivers (reducing the film effect to acute frequencies) and very low ohmic loss due to the section of 2 x 2.5 mm ² of its drivers.

This 8.2 mm external diameter cable is also highly flexible, which facilitates its manipulations and its mobile installation.

Neutrik NL2FXX-WS neutrik connectors meet the new IEC 61984 electrical safety standards and can convey a constant current of 37 A, which greatly exceeds the use of power audio, even with very low impedances (would be equivalent to around 5,500 W on 4 ohms).

The 2.5 mm ² conductive section allows a significant loss or warm -up to be transmitted a current of 25 A (approximately 2500 W on 4 ohms) for cable lengths not exceeding about twenty meters.

Important: The Cheap Cables Commonly Sold On The Market Are Most Often Predated As Having Copper Conductors, But are in Fact Made of CCA = "Copper Clad Aluminum", ie made with a multi-start aluminum Core Covered with a think Layer of Copper, Allowing External Solder. COPPER. These cables are exhaustive, but perform the well, because their electrical conductivity is low, and they are less easy to solder. They are also robust and less resistant to rediming windows. This Type of Cable is Lighter and Generates Ohmic Losses that can be meaningful in sound engineering, as well as a risk of overheating with the same cross-sectional area as a pure copper cable.

High-Quiality Speakon NL2 (1+/1-) Cable for Connecting Professional Pa Speakers

Equipped with the Latest Generation of Neutrik Speakon Connectors, XX Series, Waterproof, Robust and Ultra-Reliable. Improved Cable Clamp and Release

The cable used is the monacor SPC-525/SW, Ideal for Conveying High-Definition Power Audio To Ludspeakers, Thanks to its Multi-Stranded Ofc Pure Copper Copper Conductors (Reducing the Film Effect at High Frequencies) and very low ohmic loss to its 2 x 2.5 mm Cross-section.

This overmolded cable, with an external diameter of 8.2 mm , is also highly flexible, making it easy to handle and install on the move.

Neutrik NL2FXX-WS Connectors Meet The New IEC 61984 Electrical Safety Standards, and can Carry A Constant of 37 A, Which Far Exceds their use in Power Audio, Even at very low Impedances (Equivalent to Approx. 5500 W at 4 ohms).

The 2.5 mm ² Conductor Cross-Séction Enables A Current of 25 A (Approx. 2500 w at 4 ohms) to be transmitted without any noticeable losss or overheating, for cable lengths of no more than twenty meters.